Woven Wire Specifications
		For Woven Wire Partitions Click Here For Woven Wire Rooms Click Here For Woven Wire Doors Click Here To Plan a Woven Wire Partition Click Here Woven Wire Xtra High Partition Click Here For Woven Wire Ceilings Click Here
			PARTITIONS made of 10 gauge steel wire woven into 1 1/2" diamond mesh securely clinched to framing. Vertical frames are 1 1/4" x 5/8" cold rolled 'C' steel channels with 1/4" bolt holes. Horizontal frames are 1" x 1/2" cold rolled steel channels. All joints are mortised and tenoned. Center reinforcing bar consists of two cold rolled steel channels 1" x 3/8" riveted through wire mesh at 3'6" from floor. An additional reinforcing bar is included for 12' high partitions. Top capping bar is 1 1/2" x 1" cold rolled steel channel with 1/4" bolts 30" O.C. All partitions have a 3" sweep space and include hardware and accessories for proper installation. Partition-to-wall hardware must be ordered separately. ADJUSTABLE PANEL KIT consists of two vertical frames and hardware attached to 12" diamond expanded metal which can be cut down from 13" to 22" wide. CORNER POSTS are 1 1/4" x 1 1/4" steel angle with 1/4" bolt holes. Floor sockets are cast aluminum. Line posts are 3 1/2" x 1" x 12 gauge steel channel with 9" x 5" x 3/16" steel base plate. Recommended at 15' intervals for extra rigidity. DOOR frames are 1 1/4" x 1/2" cold rolled steel channel. Sliding doors have two four-wheel bearing truck/hangers enclosed in a galvanized steel box track and one steel channel bottom guide. Hinged doors to have 1 1/2 pairs of butt hinges bolted to door and transom frame. Locking hasps arranged for padlocking, or specify: cylinder mortise type lock operated by key outside, recessed knob inside. FINISH is one shop coat gray gloss enamel..